Metal fences have not less strength than the brick,
concrete and stone fences. Nowadays there is a huge choice of options
their manufacture. Until recently, used mainly fencing
galvanized sheet metal , are now increasingly common
profiled sheets are coated with a plastisol , polyester or
Purana.

Corrugated sheets are hundreds of shades of color and keep for 10-15
years. From a smooth or corrugated metal sheet can be made continuous
wall. But the lack of such protections is that such a fence is obtained
quite heavy (leaf area of ​​1 m2 and a thickness of 1, 5 mm and weighs about 12 kg)
and under it will lay the foundation. Profiled decking can
used instead of sheet metal. Such a sheet with the same size and thickness
flooring weighs 4-6 kg, and in addition the edges of this metal products
give the construction more rigid. Metal pipes rational
to use in the construction of a fence made of solid sheets, the sheets
joined by welding. Using corrugated board can be installed poles
metal, wood or concrete. Next, attach the decking to
prozhilinam with one or both sides. In this case, the barrier is obtained
equally decorative and from the street, and from the yard. Most
cheapest option, instead of a solid metal fence can be built
and grid when the grid openings are filled, rabitsey, forged or welded
metal sections. Metal pipes of small diameter (4-6 cm)
used as columns in the construction of fences, mesh-rabitsy.
In this version of the tube and the grid itself (if it has no protective coating)
treated with anti-corrosive composition. Poles installed in the usual way
at a distance of 2-2, 5 meters from each other. To prevent displacement of pillars
during stringing nets and corner pillars are located next to the gate
and strengthen the pillars of the gate with special braces. Facilitate the task
making a fence out of rabitsy can be bought ready-made sections, consisting
of the grid attached to a metal frame, then the need to strengthen
pillar braces fall off. Independently make such overflights
can be made of metal parts, pre-cook the frame, and attach to it
net. This can be done by welding, fasten to the frame of an ordinary rabitsu
thick wire cross section. A fence made of a metal rod is better
just install a small (not higher than 0, 5 m). The foundation must
be of brick or stone pillars punctuating the same material,
as the base of the fence. Sharp tops usually end forged
rods, which are both additional protection from unwanted
guests and decorate the fence. The most optimal height of the fence of metal
Bars - 1, 8 pm If the fence is higher rigidity is lost
and a need to strengthen and this will lead to additional rasshodam
materials. Forged, simulating a classic fence, some of
the most expensive. The process of forging is that way - the metal is stretched,
bend, changing its cross section. Hot forging machine will cost much
cheaper. Hand forging is more expensive, and it has its pluses, they are manifested in
what the smith using various technologies can give a metallic
fence kind of old iron, rolled steel, blackened silver,
various shades of copper. A small fence serves only
delimit the site can be made of poles, between which are suspended
chain. By fabricating such a fence will need: metal or plastic
poles, chains of the same material as the support. Install bollards,
usually no higher than 50-70 cm chains may be of different cross sections,
with links of various sizes, the number is also not limited. Produced
chain of cast material or a lightweight aluminum alloy. They are fixed
on special hooks or welded to the iron columns. The latter option
use and installation of structures made of plastic. Fence made of metal, if
it has no protective coating, must be regularly painted. This procedure
should be performed every 1, 5-5 years, depending on the quality of the paint.

Share This Post: