If the paint or varnish on the wooden flat strips are in poor condition
- Flaking, peeling or cracking , or a layer so thick that
door or window difficult to close, then cover must be removed.

Small areas can be cleaned with sandpaper, but it is more practical
used to remove paint solvents or hot air. Always
Use protective equipment - gloves, coveralls with long sleeves,
goggles and a respirator, and open the windows or turn on the fan. Solvent
Solvent use paint on large areas of economically inefficient,
so it is better to use the curly products, such as profiles and
eaves and window frames due to the risk of splitting when heated. Solvents
produced in the form of a gel, paste or liquid. Most of them are suitable
how to paint and paint thinner. The number of layers, one portion of the soluble
solvent depends on the properties of the solvent. Some of them require
apply several times. Before using refer to the solvent
instructions for its use. The use of hot air easiest
and economical way to remove paint and varnish is the use of electric
fan heater. When working with fan careful not to get the flow
Hot air on the hand. Useful Tips Do not use the heater
near an open window on a windy day, the wind deflects the jet of hot air
and paint can not soften. When using paint heater
could ignite. So always keep a bucket of water next to
paint particles falling into a bucket (never use newsprint).
Solvent Step 1: Removing paint from flat strips of wood
Solvents can damage the floor, so it should cover. You can use the
sheet of plywood, hardboard or several layers of newsprint.
Pour the solvent into a glass vessel. Old brush brush with solvent
the entire surface from top to bottom. Step 2: Removing paint from flat strips of wood
After a specified time in the instructions (from several minutes to several hours),
When the paint softens, scrape it wide scraper with flat areas
careful not to damage the wood. Step 3: Removing paint from flat strips of wood
To remove the paint with a shaped product, in corners and other hard-
places, use for scraping paint the relevant part of figure
scraper. Step 4: Removing paint from wood floor flat strips of polyethylene Close
film. Remove excess solvent with a wet sponge or white spirit. For
treatment slots shaped coil of wire products use. The remaining
gap in the paint can be removed with sand bath medium-grained paper. Use
Step 1: Remove heater paint with flat strips of wood Always protect
half sheet of plywood or hardboard. Contact with fan
very carefully. To remove the paint hold heater at a distance
50 mm from the surface up until the paint starts to bubble. Step
2 Removing paint from flat strips of wood shaped scraper to remove softened
paint. When removing paint, do not point the nozzle at one place - it can
charred. Move the nozzle above the surface. Step 3: Removing paint from
Some types of flat strips of wood heaters are equipped with nozzle-scraper.
This allows the heat and scrape the paint in one motion. Some types of
heaters are equipped with metal deflectors, deflector
hot air flow from heat-sensitive surfaces such as
windows. Step 4: Removing paint from flat strips of wood Whatever
removal of paint is used, always traces of paint remain. Traces
remove with sandpaper with a grain of average size for wet and dry
Stripper: fold the paper, fold, insert into the slot and strip plot reciprocating
movements.

Share This Post: